Clear Coat P2UD can be applied to concrete floors, polished and decorative concrete, face brick walls, wood surfaces including garage doors, external doors and window frames, as well as waterproofing systems and non-slip coatings. It is suitable for any interior or exterior surface that requires clear sealing and protection.
No. Clear Coat P2UD is a single-component product — ready to use straight from the container with no mixing required, no pot life limitations and no waste from unused mixed product.
A minimum of two coats is recommended, allowing each coat to dry fully before applying the next. On very porous surfaces such as bare concrete, face brick and raw wood, apply SealPro Penetrar first before applying Clear Coat P2UD.
Penetrar binds the substrate and ensures the polymer content of Clear Coat P2UD remains in the top layer of the surface where it seals and protects most effectively. Without Penetrar on highly porous surfaces, the polymer can be absorbed too deeply into the substrate, reducing the protective performance of the coating.
No. Clear Coat P2UD is UV stable and will not yellow or discolour on surfaces exposed to direct sunlight — making it suitable for exterior applications where solvent-based polyurethane coatings would typically yellow and deteriorate over time.
No. Clear Coat P2UD's water-based formula allows the substrate to breathe, preventing the moisture entrapment that causes blistering. It also penetrates and bonds directly with the substrate rather than forming a surface film — eliminating the delamination and peeling that affects solvent-based coatings over time.
Yes. Clear Coat P2UD is suitable for both interior and exterior applications. Its UV stability and water-based formula make it particularly well suited to exterior surfaces such as face brick walls, concrete floors, garage doors and external woodwork where solvent-based coatings are prone to yellowing and blistering.
Clear Coat P2UD covers approximately 5 to 6 square metres per litre per coat. Coverage will vary depending on the porosity and condition of the substrate — highly porous surfaces will require more product per coat. Apply Penetrar first on porous surfaces to improve coverage efficiency.
Yes. Clear Coat P2UD is used to seal the SealPro ArmTec HyperFlex waterproofing system once fully cured — making the surface trafficable and protecting the waterproofing membrane from surface wear and UV degradation.
Yes. Clear Coat P2UD is used to seal the SealPro ArmTec HyperFlex waterproofing system once fully cured — making the surface trafficable and protecting the waterproofing membrane from surface wear and UV degradation.
Yes. Clear Coat P2UD is water-based, low VOC and virtually odourless — safe to use indoors on occupied sites without specialist ventilation or site clearance. No solvent fumes, no fire risk during application.
Clear Coat P2UD is water-based, UV stable, non-yellowing, blister-free and safe for indoor use without ventilation. Solvent-based polyurethane sealers are prone to yellowing in UV, blistering where moisture is present, require ventilation during application and present a fire risk. Clear Coat P2UD delivers equivalent or superior protection without any of these drawbacks.
Stay on top of new products, specials and offerings we might have. Sign up today.
